First, rule out a gas leak
Low heat can have a perfectly harmless cause, but it can also be a sign of a leak. Weber says that if your grill is showing signs of being in "bypass" (more on that below), the first thing to do is perform a gas leak test, and if you find a leak, don't use the grill. The Ontario Association of Fire Chiefs adds: if you find a leak, close the cylinder valve and contact a certified gasfitter. Our guide on how to check your BBQ for a gas leak walks through the soapy water test step by step.
If you smell gas, the Weber and Napoleon owner's manuals both say to shut off the gas, put out any open flame and open the lid, and if the smell continues, keep away from the grill and immediately call your gas supplier or the fire department. Don't try to troubleshoot heat problems on a grill that smells like gas.
1. The regulator's safety device has tripped (bypass mode)
This is the big one, especially if the problem started right after a tank swap. Weber, Napoleon and Broil King all describe a safety device in the propane hose and regulator that cuts the gas back when it "thinks" there's a leak; Napoleon and Broil King say it reacts to a sudden or excess flow of gas. Broil King calls it QCC1; Weber calls the result "bypass." Weber says that in bypass the gas flow drops to about 10% or less of its normal volume, so the grill can't reach its normal temperature, and sometimes won't light at all.
Napoleon lists the usual ways it gets tripped:
- opening the tank valve too quickly
- having burners on before the tank is opened
- shutting the propane off before turning the knobs off
- leaving the control knobs on after grilling
The fix is a regulator reset. Napoleon's steps: turn everything off, including the gas at the tank; disconnect the regulator from the tank and let everything sit for about 5 minutes; reconnect it and slowly open the tank valve all the way; then wait 30 seconds before lighting. Broil King's version is the same idea: tank and grill off, disconnect, reconnect, then very slowly turn the tank back on. Napoleon's FAQ on the same page adds three details: make sure the regulator is secure and not cross-threaded, back the valve off about half a turn once it's fully open, and do a soapy water leak test on the joints and connections.
To keep it from happening again, Weber's routine is: lid open, every control knob OFF (side burner too), open the tank valve, then wait several seconds for pressure to build in the hose before you turn a knob to light. When you're done grilling, Napoleon's tip is to turn the burners off before you close the tank.
2. You're low on propane (or the hose isn't on properly)
It sounds obvious, but a nearly empty tank is one of the most common reasons Napoleon gives for a BBQ not burning hot enough. Weber's checklist asks two related questions: do you have gas in your tank, and is the hose/regulator properly secured to the tank?
Napoleon suggests two easy ways to check the level. Pour some hot tap water down the side of the tank and run your hand down it: the metal feels noticeably cooler where the propane starts. Or weigh the tank and subtract the empty weight stamped on the handle to see roughly how much propane is left.
While you've got the tank out, glance at the date stamp. Napoleon includes checking the tank's expiration date, dents and rust in its troubleshooting list, and our guide to propane tank expiry dates in Ontario shows you where to find it.
3. The burner ports or tubes are blocked
Gas has to get through the burner tubes and out of dozens of small burner ports. Grease, rust, food bits and spider webs can block them, and you get weak, patchy or uneven flames. Napoleon's troubleshooting list starts with cleaning out your burner ports and the burner tubes, and the Ontario Association of Fire Chiefs says to clean the tubes underneath the burner, because insects and debris can build up inside them.
Broil King's method, once the grill is cool: remove the burner and clear blocked ports with a soft bristle brush or a paper clip, then run a venturi brush or pipe cleaner through the whole tube while turning it. One firm rule from Broil King: never drill or file the port holes, because enlarging them will damage the burner. Broil King also notes that spiders are attracted to the smell of gas, so keep the spider guards on the air intakes at all times. When the burners go back in, make sure each one sits properly over its gas valve opening (Broil King's troubleshooting mentions realigning burners with the valve orifice), then check for a mostly blue flame.
If taking burners out isn't your idea of a fun Saturday, that's part of our BBQ deep clean: we take the grill apart and clear every burner port for consistent heat across the grill. Our guide on how often to clean your BBQ covers how to keep it from building up again.
4. Cold weather and wind
Grilling in a York Region November has its charms, but the cold works against you. Napoleon notes that in winter you'll need extra time to preheat the grill, and you'll burn more propane than usual, because cold air pulls heat out of a BBQ much like it does out of you. In its low-heat troubleshooting, Napoleon also says cold weather and wind may play a part in how your barbecue performs.
On a cold day, Weber says the hose and regulator can take longer to pressurize, so give it extra time after opening the tank before you turn a knob.
What about the myth that propane won't work in winter? Napoleon says it's very unlikely your grill won't light, even in Ontario, and that poor heating or odd-looking flames in the cold more likely mean you need a regulator reset or clean burner ports. For placement, the fire chiefs say to keep your BBQ at least one metre (three feet) from the house and away from wind and combustible materials.
5. The knobs, the lid or the preheat
Before you start taking things apart, check the simple stuff. On many grills, the "start" position on the knob is also high, and turning the knob further sets it lower. Weber asks: is it possible you are setting the grill to low instead of high? Napoleon adds another easy miss: not opening the gas valve all the way.
Then give it a fair test. Weber's check is to light all the main burners on high, close the lid, and wait 10 to 15 minutes; a properly working Weber gas grill should be in the 500 to 550°F range (about 260 to 290°C). Weber's test is done with the lid closed, so judge your grill the same way. Weber also asks whether the grill is actually cooking differently, or whether the thermometer itself may have failed.
6. Worn burners, a tired regulator or low gas pressure
If you've reset the regulator, filled the tank, cleaned the burners and preheated properly, and the grill still won't get hot, a part may be worn out. The fire chiefs say burners that are rusted or damaged should be replaced. Napoleon says that if its steps don't fix low heat, you may need to replace the regulator or seek professional assistance.
Natural gas grills are a different story: there's no tank to reset. Broil King says the water column pressure may need to be checked by a certified gasfitter, and TSSA, Ontario's fuel safety regulator, says direct-connected natural gas barbecues must be installed by a TSSA-registered fuels contractor. That's not a DIY job.
One more thing to watch while you're testing: the flame colour. The fire chiefs say propane and natural gas flames should be mostly blue with yellow tips, and if the flame is mostly yellow, do not use the BBQ and contact a qualified gasfitter.
When to call in help
Low flame and uneven heating are common BBQ problems, and they're exactly what our BBQ repair service sorts out. We come to your home, start with a full inspection to find the cause (blocked or corroded burners, a sticking valve or a worn regulator, for example), and replace the part with one that suits your make and model. We work on all major brands, including Napoleon, Weber and Broil King, and you approve every part and price before we install anything. After a repair we run safety checks, including a leak test and a test-fire of every burner.
Every grill is quoted individually. Text us a photo of the problem, plus the brand and model if you have it, or request a quote online. We serve Vaughan, York Region and the GTA.
